marlio

AP Physics 1, Unit 7

Exam words: Oscillations

The 29 words a written answer in this unit needs. For each one: what it means, a wording that loses the mark and why, and a sentence that uses it the way a full answer would.

Study these words as a deck

Flashcards, Learn, Test and Match in Cards, with your Still learning marks kept, and the booklet to print on A4 or US Letter. Sign in to open it.

The words

  1. equilibrium position

    Units: m

    The position where the net force on an oscillator is zero.

    Loses the mark: “measured from the release point”. Displacement in an oscillation is measured from equilibrium, not from where it was let go.

    Example: For the hanging spring the equilibrium position is where kx = mg, not the spring's natural length.

  2. amplitude

    AA · Units: m

    The maximum displacement of an oscillator from its equilibrium position.

    Loses the mark: “the distance from one end to the other”. That is twice the amplitude.

    Example: The glider moves between -0.1 m and +0.1 m, so its amplitude is 0.1 m.

  3. period

    TT · Units: s

    The time for one complete cycle of an oscillation.

    Loses the mark: “the time from one side to the other”. That is half a period; a full cycle returns to the start moving the same way.

    Example: The swing takes 2.4 s to go out and come back to the same point moving the same way, so its period is 2.4 s.

  4. frequency

    f=1/Tf = 1/T · Units: Hz

    The number of complete cycles per second, the reciprocal of the period, in hertz.

    Loses the mark: “frequency is how fast it moves”. Frequency counts cycles per second, not the speed of the mass.

    Example: A period of 0.5 s means a frequency of 2 Hz.

  5. angular frequency

    ω=2πf=2π/T\omega = 2\pi f = 2\pi/T · Units: rad/s

    2π times the frequency, in rad/s.

    Loses the mark: “omega equals f”. ω is 2π times f; they differ by a factor of about 6.

    Example: With T = 0.5 s the angular frequency is 2π/0.5, about 12.6 rad/s.

  6. damping

    Loss of an oscillator's energy to its surroundings, shrinking its amplitude.

    Loses the mark: “the period gets shorter as it dies away”. Light damping lowers the amplitude, not the period.

    Example: Air damping halves the pendulum's amplitude over a minute, but each swing still takes about 2 s.

  7. simple harmonic motion

    Oscillation with net force proportional to displacement from equilibrium, directed back toward it.

    Loses the mark: “any back and forth motion”. Only a restoring force proportional to displacement gives simple harmonic motion.

    Example: The net force on the glider is -kx, so its motion is simple harmonic motion with a period independent of amplitude.

  8. restoring force

    Units: N

    A net force that always points back toward the equilibrium position.

    Loses the mark: “the force in the direction it is moving”. The restoring force points toward equilibrium, which is often against the velocity.

    Example: The restoring force on the cart is -kx, so it always points back toward equilibrium, whichever side the cart is on.

  9. restoring force proportional to displacement

    The test for simple harmonic motion: restoring force proportional to displacement, F = -kx.

    Loses the mark: “it oscillates, so it is simple harmonic”. A ball bouncing on a floor oscillates but its force is not proportional to displacement.

    Example: The bobbing block has a restoring force proportional to displacement, ρgA times its depth change, so it moves in SHM.

  10. period of a mass-spring oscillator

    T=2πm/kT = 2\pi\sqrt{m/k} · Units: s

    The period of a mass-spring oscillator, 2π√(m/k), independent of amplitude.

    Loses the mark: “a bigger push gives a longer period”. The period of a mass-spring oscillator does not depend on amplitude.

    Example: Quadrupling the mass doubles the period of a mass-spring oscillator, from 0.6 s to 1.2 s.

  11. vertical mass-spring oscillator

    A mass hanging on a spring; its period matches a horizontal spring's.

    Loses the mark: “gravity changes the period of the hanging spring”. Gravity shifts the equilibrium but leaves the restoring force -kx about it.

    Example: The vertical mass-spring oscillator has the same 0.8 s period it would have lying flat; only its equilibrium shifts down.

  12. simple pendulum

    T=2πL/gT = 2\pi\sqrt{L/g} · Units: s

    A small bob on a light string, with period 2π√(L/g) at small amplitude.

    Loses the mark: “a heavier bob swings more slowly”. The bob's mass cancels; only the length and g set the period.

    Example: Swapping the brass bob for a wooden one leaves the simple pendulum's period at 2.0 s, because mass cancels.

  13. small-angle approximation

    For small angles, sin θ is close to θ in radians.

    Loses the mark: “use the pendulum formula for a 60 degree swing”. At large amplitude the approximation fails and the period is longer.

    Example: The small-angle approximation holds at 10°, but at 60° the measured period is about 7% longer than 2π√(L/g).

  14. pendulum length

    LL · Units: m

    The distance from the pivot to the center of mass of the bob.

    Loses the mark: “length of the string only”. Measure to the bob's center of mass; the string alone is too short.

    Example: The pendulum length is measured to the middle of the bob, 0.995 m, not just to the top of it.

  15. total energy of an oscillator

    E=12kA2E = \tfrac12kA^2 · Units: J

    For a mass-spring oscillator, one half k times amplitude squared, constant without damping.

    Loses the mark: “it has no energy at the end of its swing”. At the extremes all the energy is potential energy.

    Example: Doubling the amplitude makes the total energy of an oscillator four times as large, since E = ½kA².

  16. maximum speed

    vmax⁡=Aωv_{\max} = A\omega · Units: m/s

    The speed of an oscillator passing equilibrium, where all energy is kinetic: amplitude times ω.

    Loses the mark: “fastest at the ends of the swing”. At the ends it is momentarily at rest; it is fastest passing equilibrium.

    Example: With A = 0.05 m and ω = 20 rad/s, the glider's maximum speed is 1 m/s, reached at equilibrium.

  17. sinusoidal

    Shaped like a sine or cosine curve.

    Loses the mark: “the area under the position graph gives the velocity”. Velocity is the slope of the position graph, not its area.

    Example: The position-time graph is sinusoidal with a period of 0.8 s, so the velocity and acceleration graphs repeat every 0.8 s too.

  18. a quarter period out of step

    Two oscillating quantities whose peaks are a quarter period apart.

    Loses the mark: “velocity is greatest at maximum displacement”. At maximum displacement the velocity is zero; it peaks a quarter period later.

    Example: The velocity graph is a quarter period out of step with the position graph, peaking as x passes zero.

  19. acceleration opposite to displacement

    a=−ω2xa = -\omega^2x

    In SHM acceleration is -ω² times displacement, largest at the extremes and zero at equilibrium.

    Loses the mark: “maximum acceleration at the equilibrium position”. At equilibrium the net force, and so the acceleration, is zero.

    Example: With acceleration opposite to displacement, the a-t graph is the x-t graph flipped upside down and scaled by ω².

  20. uncertainty

    The range around a measured value within which the true value is expected to lie.

    Loses the mark: “±0.01 s because the stopwatch shows hundredths”. Human reaction time, about 0.1 s or more, dominates the display's resolution.

    Example: From the spread of five trials, g = 9.7 ± 0.2 m/s², so the uncertainty includes the accepted 9.8 m/s².

  21. precision

    How closely repeated measurements of the same quantity agree with each other.

    Loses the mark: “precision means it is correct”. Precise results can all be off by the same systematic error.

    Example: The five times all fall within 0.02 s of one another, so the precision is high even if a systematic error remains.

  22. accuracy

    How close a measured result is to the true or accepted value.

    Loses the mark: “more decimal places means more accurate”. Extra digits do not bring a result closer to the true value.

    Example: The accuracy of the result is good because 9.79 m/s² is within its uncertainty of the accepted value.

  23. consistent within uncertainty

    Two results agree when their difference is smaller than their combined uncertainty.

    Loses the mark: “the numbers are different so the theory is wrong”. A difference smaller than the combined uncertainty is not evidence against the theory.

    Example: The two measured speeds, 4.1 ± 0.2 m/s and 4.3 ± 0.2 m/s, are consistent within uncertainty.

  24. systematic error

    An error shifting every measurement the same way, not reduced by repeating trials.

    Loses the mark: “human error”. Too vague; name the specific source and the direction it pushes the result.

    Example: Starting the timer late is a systematic error that makes every time too short, so the calculated g comes out too large.

  25. random error

    Unpredictable scatter of readings above and below the true value, reduced by averaging many trials.

    Loses the mark: “a mistake in the calculation”. An arithmetic slip is a blunder to correct, not a random error of measurement.

    Example: Reaction time adds random error to each stopwatch reading, so I average ten trials.

  26. zero offset

    A fixed shift in an instrument's reading, such as a scale reading 0.2 N unloaded.

    Loses the mark: “the error changes the slope”. An additive offset moves the line up or down without changing its slope.

    Example: The spring scale has a zero offset of 0.2 N, so the force-extension line misses the origin but its slope still gives k.

  27. linearization

    Choosing what to plot so a predicted relationship gives a straight line.

    Loses the mark: “plot T against L because I control L”. T against L is a curve; plot T² against L to get a straight line.

    Example: For the pendulum, linearization means plotting T² against L, so the slope equals 4π²/g.

  28. intercept

    The plotted quantity's value when the horizontal quantity is zero.

    Loses the mark: “force the line through the origin”. Forcing the line hides the offset the intercept is there to reveal.

    Example: The T² against L line has an intercept of 0.04 s², suggesting the length was measured short.

  29. line of best fit

    A straight line with data points scattered evenly on both sides of it.

    Loses the mark: “join the dots”. Connecting points follows random error; a best-fit line averages over it.

    Example: The line of best fit through the six points has a slope of 4.0 s²/m, giving g = 9.9 m/s².